|
The Titan range of mast mounted amplifiers has
been completely reengineered and updated. These amplifiers
represent the ultimate in preamplifier performance.
Full lightning and surge protection.
• Uninterrupted operation even under the harshest environmental
conditions.
• Optimum filtering for rejection of out-of-band signals.
• Ultra linear transistors provide high output capability for
optimum signal handling.
• High gain and ultra low noise figure from latest generation
transistors give optimum sensitivity.
• Simple installation -hardware included.
• Rugged die-cast aluminum housing -fully shielded.
• Surface-mounted components for automated production and
consistent high performance.
• Cool running, redesigned 117 VAC power supply, Model 0747 is
included with each model. Output voltage is +18VDC. UL and cUL
listed, Power supply also available as a separate model.
• Power supply and pre-amp are connected to the antenna using
RG6 coax cable. An RG6 cable is run from antenna to pre-amp,
from pre-amp to power supply, then from power supply to
television. Power supply does not have to be outdoors.
Additional Information
A Pre-Amplifier (pre-amp) is a mast or antenna mounted amplifier
used primarily to eliminate "snow" on the TV screen. Snow is
actually electrical noise that is generated by the TV receiver
and other electrical devices. The objective of any antenna
installation is to deliver enough signal to the TV set to
override the noise (snow). A "weak" signal is one that is not
strong enough to override the level of the noise in the set.
Another obstacle is the signal loss incurred while traveling
through the transmission line connecting the antenna to the TV
set. An antenna that has acceptable gain at the antenna tapoffs
but encounters excessive loss due to long cable runs will also
deliver a "snowy" picture to the TV set due to not enough signal
makes it to the set to override the noise level. A pre-amp would
be used to compensate for the losses in the transmission line as
well as the noise level of the set.
TITAN 2TM
MATV Mast Mounted Preamplifiers
The Titan range of mast mounted amplifiers has been completely
reengineered and updated. These amplifiers represent the
ultimate in preamplifier performance. They are designed for use
as an ultra low noise, ultra high gain preamplifier for deepest
fringe applications and MATV headend applications.
Their very high signal handling also makes them suitable for use
as a mast mounted, ultra low noise distribution amplifier for
use in small MATV systems. All models feature 75 ohm, input and
output connections in line with modern headend engineering
practice.
SPECIFICATIONS:
Number of Inputs: ½ (VHF & UHF)
Input and Output Impedance: 75 Ohms
Input and Output Connectors: F Type Connectors
VHF Gain: 23 dB
VHF Noise Figure: 2.8 dB
VHF Output Capability: 57 dBmV
Switchable FM Trap
UHF Gain: 26 dB
UHF Noise Figure: 2.0 dB
UHF Output Capability: 51 dBmV
View
Larger Picture
 |
